Transom mount for sculling oar v2.

Discuss the Jerry Montgomery designed pocket cruiser SAGE 15 (sloop) and SageCat (catboat version of the Sage 15)

Moderator: sal

Message
Author
noel
Posts: 76
Joined: Sun Jun 01, 2014 12:27 pm

Transom mount for sculling oar v2.

#1 Post by noel » Sun Apr 28, 2019 10:15 am

Motors fail, wind disappears. Need an alt source of propulsion.

Sculling oar mount (SOM)v1 worked fine, but..... Practical function issue. Clamps on to the motor mount. Requires removing motor before attachment. Removing an outboard from a rolling, pitching sailboat is no fun. SOM v2 is a transom mounted model. Sandwiches the transom. Dry fitting it seems to be functional. Plus it takes less than a minute to attach and detach. Right now the penetrating epoxy is curing. After a few coats of marine varnish and permanent attachment of some hardware it will be ready for an on the water test. Total cost less hardware $0.00. Lumber salvaged from my “junk” pile.

For those interested is building a sculling oar that packs down to a 4 foot bundle. Recommend the cf ferrule (~$30) and Scullmatrix(~$37) available from duckworks.com. Oar used is the Caviness BW-SU series 8 footer. The Scullmatrix requires a fat 1 3/4” diameter oar. The BW-SU required ~1/8” build up. Caviness does sell a break a part oar. The 100J, but it’s only 1 1/2” and max length of 7 feet.